歡迎您光臨康鵬華彩新能源技術有限公司官網!

聯系我們 收藏本站

咨詢服務熱線 工業油電話:0531-58589003,13256121992
車輛油:0531-87581191,13156111992

熱門關鍵詞搜索: 潤滑油工業潤滑油 潤滑油廠家

您的當前位置:主頁 > 新聞資訊 > 常見問題 >

導熱油廠家介紹導熱油使用的注意事項

來源:www.202000.live 編輯者:康鵬華彩新能源 發布日期:[2017-07-11 14:17] 瀏覽:|

  導熱油廠家介紹導熱油使用的注意事項:

  Heat conduction oil factory introduces the precautions of heat conduction oil:

  1、運行中嚴禁超溫使用,確保導熱油的正常使用壽命。

  1, the operation is strictly prohibited overheating use, to ensure the normal service life of heat conduction oil.

  2、按導熱油的牌號及用熱工藝要求,正確選用各種牌號節能導熱油,并嚴格各項規定,正確使用導熱油。

  2, according to the heat transfer oil grade and the thermal process requirements, correctly select all kinds of energy-saving heat conduction oil, and strict regulations, the correct use of heat transfer oil.

  3、在使用中應認真檢查,嚴防水、酸、堿及低沸點物漏入使用系統,并加裝過濾裝置,防止機械雜物進入,確保油品純度

  3, in use, should be carefully checked to prevent water, acid, alkali and low boiling point leakage into the use of the system, and the installation of filtering devices to prevent the entry of mechanical debris, to ensure purity of oil

  4、節能導熱油適用于燃煤、燃氣、燃油加熱熱爐作載熱體,電加熱反應釜等供熱設備使用時,應具有膨脹槽和貯槽及其它安全組件和溫控儀表等配套設施,確保安全運行。

  4, energy-saving heat conducting oil used as heat carrier to coal, gas and oil heating furnace, electric heating reactor and other heating equipment used, should be expanded and tank and other security components and temperature control instrumentation and other facilities, to ensure safe operation.

  5、凡舊供熱設備更換新導熱油時,必須消除內壁雜物,以免影響導熱油的傳熱效率和使用壽命。

  5, where the old heating equipment replacement of new heat transfer oil, you must eliminate debris on the wall, so as not to affect the heat transfer oil efficiency and service life.

  6、高溫導熱油經使用半年后,應進行一次油品分析。若長期使用后,發現傳熱效果差、或發現異常情況,應根據油品分析結果決定(主要控制項目,殘炭不大于1.5℅,酸值不大于0.5mgKOH/g,閃點變化不大于20℅,粘度變化不大于15℅)若其中一項不合格時應考慮添加部分新油或全部更換新油。

  6, high temperature heat transfer oil after six months, should be a oil analysis. If used for a long time, it is found that the heat transfer effect is poor, or the abnormal situation, should be decided according to the oil analysis (mainly carbon residue control project, not more than 1.5 percent, the acid value is less than 0.5mgKOH/g, the change of the flash point of not more than 20 percent, the viscosity change is not greater than 15 percent) if one is not qualified should be considered when adding some new oil or oil to replace all.

  7、導熱油投入使用,在開始運行時先啟動循環油泵運行半小時后,再點火升溫,在初次使用時應緩慢升溫每小時20℃,當溫度升至130℃左右時,要保溫一段時間,當溫度升至180℃-200℃時再保溫一段時間后方可投入正常使用。

  7, oil is put into use, at the start of operation to start the pump running after half an hour, and then the ignition temperature, is used for the first time should be slow to warm up every hour 20 degrees, when the temperature rose to 130 degrees Celsius, to be preserved for a period of time, when the temperature rise to 180 DEG -200 DEG again when the holding time behind can be put into normal use.

同類文章:

文章標題:導熱油廠家介紹導熱油使用的注意事項

推薦閱讀/ Recommended reading

礦物導熱油(有 機熱載體)屬于烴類有 機物,與空氣或具有氧化作用的物質接觸時會發生氧化反應,生成有 機酸,有 機酸的存在又會進一步加速導熱油的聚合和裂解反應。例如,高溫...

導熱油廠家分享如何挑選優質導熱油?[2018-07-19]
潤滑油并非黏度越高就越好[2017-11-20]
如何選擇適合的柴油發動機潤滑油?[2018-07-16]
導熱油(有機熱載體)使用注意事項[2019-09-17]
潤滑油廠家教您如何選擇潤滑油?[2018-07-30]
什么是導熱油閃點?[2017-08-31]
潤滑油的粘度越大越好么?[2018-10-12]
何時更換潤滑油受三因素影響[2017-12-11]
怎么樣能延長導熱油的使用時間[2017-11-13]
潤滑油小知識[2018-04-08]
  • 掃一掃,訪問手機站
注册就送可以提现的棋牌大全